‘EXTREMELY DANGEROUS’ CALLIPERS ON THE MARKET SAYS REMANUFACTURER

Not all brake callipers are remanufactured to the same standard’ according to Wrexham-based Brake Engineering. 

In a statement issued to CAT, the firm says that it has seen problems in this category in the market. 

“Not all callipers available in the market today are remanufactured the same” the statement reads. “Several competitor units we have tested are being sold with reclaimed pistons, which could result in component failure or splitting the piston seal”. 

“These callipers also have had mounting holes and castings machined. A machined mounting hole could alter the critical dimensions of the calliper and increase the wear and strain during use. Machined castings could again alter the critical dimensions of the unit, increase the original pad gap and create uneven pad wear, which would result in brake squeal or brake judder”.

The firm also reported that the quality of new-in-box callipers was variable. “Currently, there are also a number of ‘new’ callipers entering the market. We have also tested a number of these callipers being sold on to independent garages. While these products may appear fit for purpose there performance has been found to be severely questionable. While aesthetically they look fine, under closer testing all units were shown to have “porosities” (holes) and oxides in the material and all had partly inhomogeneous microstructures, which could result in weakening of the unit and be extremely dangerous when braking under normal driving conditions” the statement concluded. 

We’ll be following up the company’s assertions in September’s remanufacturing feature. 

 

Published by GregWhitaker

Editor of CAT Magazine and an experienced motoring journalist

IGA DONATES £20k TO BEN

RMI’s independent garage body writes charity cheque

Read More

NISSAN TRADE CLUB CUTS PRICES BY AVERAGE OF 28 PERCENT

Prices down on ‘Value Advantage’ range to compete against aftermarket suppliers

Read More

63 PERCENT OF DEALERS PLAN TO HIRE MORE TECHNICIANS IN 2021

Retail industry bullish about 2021, in spite of huge cutbacks in 2020

Read More

ECP COLLECTS PENNIES FOR BEN

10K raised by offering to add 25 pence to till transactions in branches

Read More

99.7 PERCENT OF GARAGES OPENED THROUGH LOCKDOWN

Vast majority of sites open through England’s second lockdown in a survey of 5,000 workshops

Read More

Join the debate

3 Comments

Leave a Reply to barry Cancel reply

Your email address will not be published. Required fields are marked *

  1. made in India, no doubt. The quality of metal components (and cable for that matter) coming from that region currently, is abysmal