Inside Line: Petronas

by

With a comprehensive range of high powered, high capacity engines its important to pay attention to the correct engine oil recommendation.

All engines require synthetic products respecting Ford and BMW specifications, with viscosity grades ranging from 5W-20, 5W-30 and 5W-40. Engine oil change interval is typically 15,000 miles / 12 months, but this will be dependent on conditions and application, ie towing heavy loads.

ZF Automatic transmissions use a specific Lifeguard fluid, or Dexton III synthetic, its important to check the recommendation and that the product meets the correct ZF classification the same goes for transfer case and differentials, these are highly rated units and the lubricant plays a key part in the componants performance. Coolant is a long-life OAT type product, brake fluid DOT 4 synthetic. Power steering is Dexron III synthetic product.

VM DATA ACCESS THREAT KEY THEME OF IAAF CONFERENCE

The battle for BER renewal and the right to repair in face of VMs locking down systems on-board vehicles were a key theme of the IAAF Conference held on December 3. By necessity, the event […]

Read More

IGA DONATES £20k TO BEN

RMI’s independent garage body writes charity cheque

Read More

NISSAN TRADE CLUB CUTS PRICES BY AVERAGE OF 28 PERCENT

Prices down on ‘Value Advantage’ range to compete against aftermarket suppliers

Read More

63 PERCENT OF DEALERS PLAN TO HIRE MORE TECHNICIANS IN 2021

Retail industry bullish about 2021, in spite of huge cutbacks in 2020

Read More

ECP COLLECTS PENNIES FOR BEN

10K raised by offering to add 25 pence to till transactions in branches

Read More

Go to comments

Your email address will not be published. Required fields are marked *